Comments
RNase-ExitusPlus™ is a non-alkaline, non-corrosive and non-carcinogenic cleaning solution that is highly active against RNase contamination. RNase-ExitusPlus™ has been demonstrated to inactivate more than 20 μg of RNase A dried onto the bottom of a microcentrifuge tube. RNase-ExitusPlus™ is stable for approx. 15 months. RNase-ExitusPlus™ is ready-to-use for eliminating RNase from any surface including the interior of microcentrifuge tubes. By following the simple decontamination instructions below, RNase is completely inactivated and removed. RNase-ExitusPlus™ should be stored at room temperature; at lower temperatures a precipitate may form which is easily brought into solution at 37°C. To decontaminate pipettors: Following manufacturers instructions; remove the shaft from the pipettor and remove seals and gaskets from the shaft. Soak the shaft for one minute in RNase-ExitusPlus™, rinse the shaft thoroughly with water, let dry and reassemble. To decontaminate laboratory surfaces: Apply RNase-ExitusPlus™ directly to the lab surface. Wipe thoroughly with a paper towel, rinse with water and dry with a clean paper towel. To decontaminate laboratory apparatus: Generously apply RNase-ExitusPlus™ to a paper towel and wipe all exposed surfaces of the apparatus thoroughly. Rinse with water and dry with a clean paper towel. To clean small parts, briefly soak them in RNase-ExitusPlus™, rinse with water and dry. To decontaminate plastic and glass vessels: Add ample RNase-ExitusPlus™ to enable coating the entire surface of the vessel by swirling or vortexing. Discard the solution and rinse vessels thoroughly two times with distilled water. RNase-ExitusPlus™ is a registered trademark of AppliChem GmbH.
